sE Electronics - Dynacaster

Artnr: IDS0113498
Tarneaeg: 2-10 tööpäeva.

Teave:

The DynaCaster has been designed from scratch to set a new standard for broadcast-style microphones. Its brand-new DMC8 capsule and integrated DYNAMITE preamp provide better sonic reproduction, more sensitivity, and less noise than the standards of decades past. The capsule has a patented shock absorption system built into its body, preventing the need for a bulky external shockmount. Best of all, the three recessed switches on the rear of the microphone allow you to tune the DynaCaster to your specific tonal needs.

The DynaCaster is compatible with all broadcast boom arms. Furthermore, the XLR jack is integrated into the stand mounting point for unobtrusive cabling and a low profile for on-camera applicatons. The internal three-layer pop filter is removable for cleaning, and designed to offer enough plosive protection to be used without an external “chunky“ pop filter. However, we’ve included an external windscreen, just in case that suits your preference.

The DynaCaster is not just a speaking microphone. It can be used for singing, acoustic instruments, and miking amplifiers. All of the features that make it great for broadcast applications double as tone-tailoring options when recording and performing music!

DYNAMITE I/O Switch
When the DYNAMITE I/O Switch [middle] is in the “on” position, the DynaCaster’s internal DYNAMITE preamp provides 30 dB of additional gain, ideal for speech and softer sources. This requires Phantom power.

In the “off” position, the DynaCaster functions as a completely passive microphone, not requiring any external or Phantom power.

Low Frequency Trim
The microphone’s Low Frequency Trim [left] switch gives you three
different options for it low-end character. The center position is flat, or unaffected. The downward position attenuates the lows to reduce boominess, also known as the proximity effect. In the upward position, the lows are slightly boosted, giving the microphone’s sound some extra richness. This can be helpful when speaking from a farther distance, or miking an instrument that sounds a bit thin.

High Frequency Trim
The microphone’s High Frequency Trim [right] switch gives you three different options for its presence character. The downward position is flat, or unaffected. The center position creates a slight high- frequency boost to add clarity, and help your voice cut through a busy background. The fully upward position boosts the highs through the presence range, helping to correct for rooms where acoustic treatment has absorbed too much treble.

The Three-Layer Pop Filter
Broadcast microphones are a staple of social media channels that are distributed as video, in addition to audio. One of the issues we tried to address in designing the DynaCaster is the visual disruption of external windscreens and pop filters. To keep your video looking clean, the DynaCaster has an internal three-layer pop filter. This concept has been extensively tested to stand up to plosives, without the need for any external protection.

The three-layer pop filter and microphone grille can be easily removed and cleaned as needed. Simply turn the speaking surface of the microphone counter-clockwise to remove it. From there, the pop filter will easily lift out. Use a soft cloth, moistened with water only. Do not use any cleaning agents or aggressive liquids. Once clean, reassemble the mic and turn the speaking surface clockwise until tight. You’re ready to go!